Xerox 3315/DN Benutzerhandbuch

Fax Setup

Xerox WorkCentre 3315DN/3325DN/3325DNI
User Guide

166

Fax Setup

Your machine provides you with various user-selectable options for setting up the fax system. You can 
change the default settings for your preferences and needs.

Enable/Disable

Use this option to enable or disable the Fax service:

1.

Press Machine Status on the control panel.

2.

Press the up/down arrows to highlight Fax Setup and press OK. If necessary, enter the 
Administrator’s Password

 using the keypad. Refer to 

on page 154 for 

instructions.

3.

Press the up/down arrows to highlight Enable/Disable and press OK.

4.

Press the up/down arrows to highlight Enabled or Disabled. Press OK.

5.

Press Stop to return to Ready mode.

Sending

1.

Press Machine Status on the control panel.

2.

Press the up/down arrows to highlight Fax Setup and press OK.

3.

If necessary, enter the Administrator’s Password using the keypad. Refer to 

on page 154 for instructions.

4.

Press the up/down arrows to highlight Sending and press OK.

The following Sending options and settings are available:

Note:

* indicates the factory default setting.

Redial Times

You can specify the number of redial attempts. If you 
enter 0, the machine will not redial.

•

0  -  13  Times
7 *

Redial Term

Your machine can automatically redial a remote fax 
machine if it was busy. You can set an interval between 
attempts.

•

1  -  15  Minutes
3 *

Prefix Dial

You can set a prefix of up to five digits. This number 
dials before any automatic dial number is started.

•

Fax: (enter up to 5 
numbers to set the 
prefix)

ECM (Error Correction 
Mode)

This mode helps with poor line quality and makes sure 
any faxes you send are sent smoothly to any other 
ECM-equipped fax machine. Sending a fax using ECM 
may take more time.

•

On *

•

Off

Send Report

Enables or disables printing of a confirmation report 
showing whether the fax was successful or not.

•

On Error *

•

On

•

Off