Citizen Systems CMP-10 Benutzerhandbuch

— 32 —

This kit consists of a belt clip, two screws, and two rubber feet.

Peel off the cover seal in the square frame at the bottom of the CMP-10
carefully.
Mount the belt clip in the square frame using the two screws supplied.
The direction of the belt clip should be as per the drawing below.

Note:

Do not use screws without mounting the belt clip.  The screws

when mounted alone reach too deep and may come in contact with the
internal circuit board and cause a failure.

Confirm that the grooves for the rubber feet are clean and neither dust
nor oil is present on the grooves for rubber feet.
Peel off the liner sheet of the adhesive seal for rubber foot and carefully
fit the rubber foot to the groove. Press and hold to secure the rubber
foot.

Belt clip

Grooves for rubber feet