Citizen Systems CLP-521 Benutzerhandbuch

22

Media holder bar

Media holder guide

Large blue-head open lever

2. Firstly, slide the two black plastic parts of the media holder

assembly together. Ensure correct alignment of the guide with
the bar as it can only be installed in one direction.

3. Slide the roll of media over the media bar.  The media guide

must be on the right side of the roll of media (as viewed from
the front of the printer) with the flat surface of the media guide
touching the roll.

1. Push the large blue-head open lever to release the head unit

and sensor arm. It can be opened to the position shown below
by lifting the head unit by hand.

4. Set the media roll and media holder in to the printer as shown

above.  It is advisable to pull a length of media forwards and
through the mechanism ready for later positioning.

5. Move the media roll so it is touching the leftside of the housing.

Then slide the black media guide so it is touching the media on
the right side.  Do not try to hold the media too tightly with
these guides as it will cause the printer to jam during printing.