Epson C11C686201 Benutzerhandbuch
Caution: Do not open ink cartridge packages until you are ready to install
the ink. Cartridges are vacuum packed to maintain reliability.
the ink. Cartridges are vacuum packed to maintain reliability.
If anything is missing, contact Epson
®
as described on the back
in “Any questions?”.
Remove all the tape.
Unpack
1
Start Here
*411016800*
*411016800*
Install ink cartridges
4
Note: Don’t load paper before installing the ink cartridges.
1
Lift up the scanner.
2
Open the cartridge cover.
3
Unpack the ink cartridges.
4
Remove only the yellow tape from each cartridge.
Caution: Don’t remove any other seals from the cartridges.
3
Close the scanner.
Note: Don’t connect the RX680 Series
to the computer yet.
to the computer yet.
3
Load paper against the right edge guide and behind the tab, with the
printable side face up.
printable side face up.
Note: Don’t load the paper sideways;
always load it short edge first.
always load it short edge first.
4
Slide the edge guide over.
Front paper cassette
1
Pull out the paper cassette.
2
Lift off the cover.
3
Press in the tab on each edge
guide and slide them to fit the
paper you are loading.
guide and slide them to fit the
paper you are loading.
4
Load paper with the printable side
face down.
face down.
Note: Don’t load paper above the
arrow mark inside the paper guide.
arrow mark inside the paper guide.
5
Fit the edges of the paper
against the paper guides.
against the paper guides.
Note: Make sure the paper
fits properly.
fits properly.
6
Replace the cover and insert the cassette back into the printer.
Rear sheet feeder
1
Open the paper support and pull up its extension.
2
Slide the edge guide to the left.
5
Load paper
Paper support
Brighter or
glossier side
down
1
Make sure the scanner
is open.
is open.
2
Connect the USB cable (not included) and route it through the slot.
Connect USB cable
2
1
Connect the power cable.
2
Press the
On button.
Turn on the RX680 Series
3
5
Insert the cartridges in
the holder for each color.
the holder for each color.
6
Press the cartridges down until they click.
7
Close the ink cartridge cover and press it
down until it clicks.
down until it clicks.
8
Close the scanner.
9
Press the OK button to charge ink. Charging takes about 2
1
/
2
minutes.
Caution: Don’t turn off the RX680 Series while the
On light is
flashing or you’ll waste ink.
8½ x 11
4 x 6 or 5 x 7
8½ x 11
4 x 6 or 5 x 7
Brighter or glossier side up