Epson 100 Benutzerhandbuch

You may sometimes need to stop a command or program while

it is running. Many application programs provide a command

you can use to cancel or even undo an operation. If you have
entered an MS-DOS command that you want to stop, try one
of the following commands:

Hold down the Ctrl key and press C

Hold down the Ctrl key and press Break.

These methods may also work in your application program. If
you cannot stop a particular operation, however, you may need

to reset the computer, as described in the following section.

C a t i o n

It is best not to turn off the computer to stop a program or

command. If you have created new data that you have not
yet stored, it will be erased if you turn off the computer. The

Apex stores your data in its memory until you save it; but

the memory area is erased each time you turn off or reset the

computer.

Occasionally, you may want to clear the computer’s current
settings or its memory without turning it off. This is called
resetting the computer.

You can reset the computer to reload the operating system. You

may need to do this if an error occurs and the computer does

not respond to anything you enter on the keyboard; you can

reset the computer and try again. However, resetting erases any
data in the computer’s memory that you have not stored; so

reset your computer only if