Samsung ML-330X Benutzerhandbuch
Wireless network setup
29
2. Using a network-connected machine
Choosing your type
There are two methods available to connect your machine to a
wireless network using the
wireless network using the
(WPS) button on the control panel.
The Push Button Configuration (PBC) method allows you to
connect your machine to a wireless network by pressing both the
connect your machine to a wireless network by pressing both the
(WPS) button on the control panel of your machine and the WPS
(PBC) button on a Wi-Fi Protected Setup™ (WPS)-enabled access
point (or wireless router) respectively.
(PBC) button on a Wi-Fi Protected Setup™ (WPS)-enabled access
point (or wireless router) respectively.
The Personal Identification Number (PIN) method helps you
connect your machine to a wireless network by entering the
supplied PIN information on a Wi-Fi Protected Setup™ (WPS)-
enabled access point (or wireless router).
connect your machine to a wireless network by entering the
supplied PIN information on a Wi-Fi Protected Setup™ (WPS)-
enabled access point (or wireless router).
Factory default in your machine is PBC mode, which is
recommended for a typical wireless network environment.
recommended for a typical wireless network environment.
To change the WPS mode , press
(Menu) > Network >
Wireless > OK > WPS Setting.
Machines with an display screen
► Connecting in PBC mode
1
Press and hold the
(WPS) button on the control panel for
more than 2 seconds.
The machine starts waiting for up to two minutes until you
press the WPS (PBC) button on the access point (or wireless
router).
press the WPS (PBC) button on the access point (or wireless
router).
2
Press the WPS (PBC) button on the access point (or wireless
router).
router).
The messages are displayed on the display screen in the order
below:
below:
a Connecting:
The machine is connecting to the access
point (or wireless router).
b Connected:
When the machine is successfully connected
to the wireless network, the WPS LED light stays on.
c AP
SSID:
After completing the wireless network
connection process, the AP’s SSID information appears on
the display.
the display.