Samsung CLP-775 SERIES Benutzerhandbuch

Media and tray_ 46

•

To prevent transparencies from sticking to each other, do not let the 

printed sheets stack up as they are begin printed out. 

•

Recommended media: Transparency for color laser printers produced 

by Xerox, such as 3R 91331(A4) and 3R 2780(Letter), are 

recommended. 
Base type transparency (ex. Xerox 3R3117) results in better image and 

paper handling quality than paper backed (ex. Xerox 3R3028) or 

removable stripe (3R3108) ones.

•

Transparency with static electricity can cause image quality 

problems. 

•

Depending on the selection or storage conditions of the 

transparency, jam or image scratch might occur.

To avoid damaging the machine, use only labels designed for use in laser 

machines.

•

When selecting labels, consider the following factors:

-

Adhesives:  The adhesive material should be stable at your 

machine’s fusing temperature. Check your machine’s specification to 

view the fusing temperature. (See "General specifications" on 

-

Arrangement:  Only use labels with no exposed backing between 

them. Labels can peel off sheets that have spaces between the 

labels, causing serious jams.

-

Curl:  Prior to printing, labels must lie flat with no more than 13 mm 

of curl in any direction.

-

Condition:  Do not use labels with wrinkles, bubbles, or other 

indications of separation.

•

Make sure that there is no exposed adhesive material between labels. 

Exposed areas can cause labels to peel off during printing, which can 

cause paper jams. Exposed adhesive can also cause damage to 

machine components.

•

Do not run a sheet of labels through the machine more than once. The 

adhesive backing is designed for only a single pass through the 

machine.

•

Do not use labels that are separating from the backing sheet or are 

wrinkled, bubbled, or otherwise damaged.

•

Do not print on media smaller than 76 mm (3 inches) wide or 127 mm (5 

inches) long.

•

In the software application, set margins at least 6.4 mm (0.25 inches) 

away from the edges of the material.

•

Letterhead/ Preprinted paper must be printed with heat-resistant ink that 

will not melt, vaporize, or release hazardous emissions when subjected 

to the machine’s fusing temperature for 0.1 second. Check your 

machine’s specification to view the fusing temperature. (See "General 

specifications" on page 91.)

•

Letterhead/ Preprinted paper ink must be non-flammable and should not 

adversely affect machine rollers.

•

Forms and letterhead should be sealed in a moisture-proof wrapping to 

prevent changes during storage.

•

Before you load letterhead/preprinted paper, verify that the ink on the 

paper is dry. During the fusing process, wet ink can come off preprinted 

paper, reducing print quality.

When loading used paper, printed side should be facing up with an uncurled 

edge at the front. If you experience problems with paper feed, turn the paper 

around. Note that print quality is not guaranteed.

•

Used paper must be printed with heat-resistant ink that will not melt, 

vaporize, or release hazardous emissions when subjected to the 

machine’s fusing temperature for 0.1 second. Check your machine’s 

specification to view the fusing temperature. (See "General 

specifications" on page 91.)

Face up

Face down

Face down

Face up