Primera Technology DP-XRn Benutzerhandbuch

: The information in this document is subject to change without notice. NO WARRANTY OF

ANY KIND IS MADE WITH REGARD TO THIS MATERIAL, INCLUDING, BUT NOT LIMITED TO,
THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR 
PURPOSE. No liability is assumed for errors contained herein or for incidental or consequential 
damages in connection with the furnishing, performance, or use of this material. This document 
contains proprietary information that is protected by copyright. All rights are reserved. No part of 
this document may be photocopied, reproduced, or translated into another language without prior
written consent.

: Windows is a registered trademark of Microsoft Corporation. 

All other trademarks are the property of their respective owners.

Edition 1.0, #061507, Copyright 2007, All rights reserved.

: This device complies with part 15 of the FCC rules. Operation is 

subject to the following two conditions: (1) this device may not cause harmful interference, and 
(2) this device must accept any interference received, including interference that may cause 
undesired operation.

For Users in the United States

: This product is intended to be supplied by a UL listed Direct Plug-

In Power Supply marked "Class 2"or a UL listed ITE Power Supply marked "LPS" with output rated
12VDC, 4.5A or higher. This equipment has been tested and found to comply with the limits for a 
Class A digital device, pursuant to Part 15 of the FCC Rules. In a domestic environment this product
may cause radio interference, in which case the user may be required to take adequate measures. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

•

Re-orient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected.

•

Consult the dealer or an experienced radio/TV technician for help.

Use of shielded cables is required to comply with the Class A limits of Part 15 of the FCC Rules. You
are cautioned that any changes or modifications not expressly approved in this manual could void
your authority to operate and/or obtain warranty service for this equipment.

: This digital apparatus does not exceed the Class A limits for radio noise for

digital apparatus set out on the Radio Interference Regulations of the Canadian Department of
Communications. Le present appareil numerique n'emet pas de bruits radioelectriques depassant les
limites applicables aux appareils numeriques de la class A prescrites dans le Reglement sur le 
brouillage radioelectrique edicte par le ministere des Communications du Canada.