Primera Technology LX900 Benutzerhandbuch

Max

Min

Label width

8.25" (209mm)

0.75" (19mm)

Liner/media width

8.375" (212mm) 1.5" (38mm)

Label height/length

17" (431mm) 

0.75" (19mm)

Gap between labels

10" (253mm)

0.10 (2.5mm)

Width of thru-hole 

0.5" (12.65mm)

0.25" (6.325mm)

opening
Distance from edge of 

2.25" (57mm)

0.20" (5.06mm)

media to edge of 

thru-hole

Reflective

/

Black 

N/A 

0.1" (2.54mm)  

Mark

 Width*

Max Outer Diameter (OD) 6.0"(152.4mm) 

N/A 

Inner Core Diameter (ID) 3.0" (76.2mm)

3.0" (76.2mm)  

Total Thickness 

.0075” 

N/A 

(Liner + Label)**

(7.5 mil)

Distance from edge of 

Printer driver assumes 2 mm gap. 

media to edge of label

However, this is adjustable via the 

left margin offset

. 

* The Reflective/Black Mark should be opaque to infared light. The

mark should be between the labels. The end of the mark should 

correspond with the beginning of the label. 
**There are two factors that determine whether the printer will accept

any particular stock thickness. 
1.  The ability for the printer to pull the paper through the print area. 
2.  The ability for the sensor to read through the backing if the 

sensor is set to diecut. 

If you are printing in 

continuous

 or reflective label sensing mode

number 2 does not apply.  The fact that the printer must read through

the backing in 

die-cut

 mode will limit the thickness much more than

the printers ability to pull the paper through the print area. However,

if you adjust opacity level of the liner enough to allow the label to be

seen by the stock sensor, the thickness will only be limited by the

printers ability to pull it through the printer area.  For these reasons

the weight or thickness of the liner is a variable that can not easily be

defined. Primera recommends and uses 40# liner with all label stock.

LX900.qxd  4/21/2010  12:39 PM  Page 6