Ricoh AP1400/AP2000 Benutzerhandbuch
Replacing Parts
12
2
Printing the Test Page
You can confirm that the printer
works properly by printing a test
page (configuration page).
works properly by printing a test
page (configuration page).
A
Insert the plug of the power cord
securely into the wall socket.
Turn the printer's power switch
on.
securely into the wall socket.
Turn the printer's power switch
on.
B
Load paper with the print side up
into the paper tray. Slide the pa-
per tray into the printer until it
stops.
into the paper tray. Slide the pa-
per tray into the printer until it
stops.
Note
❒ If you have an optional paper
feed unit, repeat the above pro-
cedure for the tray.
cedure for the tray.
C
Move the printer to the place
where it was installed. If you
have the optional paper feed unit,
place the printer securely on the
unit.
where it was installed. If you
have the optional paper feed unit,
place the printer securely on the
unit.
D
Print the test page following the
procedure below:
A Press {{{{
procedure below:
A Press {{{{
Menu
}}}}.
The following message appears
on the panel display.
on the panel display.
Main Menu: j
Job Control l
B Press {{{{U
U
U
U}}}}{{{{T
T
T
T}}}} until the follow-
ing message appears on the
panel display.
panel display.
Main Menu: j
List Print l
C Press {{{{
Enter
}}}}.
The following message appears
on the panel display.
on the panel display.
List Print: j
1.Config. Page l
D Press {{{{
Enter
}}}}.
The following message appears
on the panel display.
on the panel display.
Config. Page
Press Enter Key
E Press {{{{
Enter
}}}} .
In a short time, the test printing
will start.
will start.
E
If you can complete the test print-
ing completely, turn off the print-
er's power switch.
ing completely, turn off the print-
er's power switch.
Note
❒ If you cannot complete the test
printing completely, confirm
that all of the parts are installed
correctly referring to the men-
tioned procedures.
that all of the parts are installed
correctly referring to the men-
tioned procedures.
F
Attach the interface cable to the
interface connector of your print-
er. Turn on the printer's power
switch.
interface connector of your print-
er. Turn on the printer's power
switch.
TS4M250E