Ricoh AP1400/AP2000 Benutzerhandbuch
Installing Options
24
2
Important
❒ The memory unit can be damaged
by small amount of static electrici-
ty. Before touching it, touch some-
thing metal to remove static
electricity from you.
ty. Before touching it, touch some-
thing metal to remove static
electricity from you.
❒ To make the printer recognize the
installed option, you should set up
the option with the printer driver.
the option with the printer driver.
❒ This printer has one slot for a
SIMM, and you can install one
SIMM at a time.
SIMM at a time.
A
Be sure to check the following
points:
• The printer's power switch is
points:
• The printer's power switch is
turned off.
• The power cord is unplugged
from the wall outlet.
B
Remove the back plate.
Note
❒ A coin can be used to remove
the screws.
C
Make sure that the notch of the
memory unit should be down-
ward as shown in the illustration.
Tilt the memory unit to the right
so that it is in 45 degrees from per-
pendicular to the slot, and slide it
into the slot (
memory unit should be down-
ward as shown in the illustration.
Tilt the memory unit to the right
so that it is in 45 degrees from per-
pendicular to the slot, and slide it
into the slot (
A). Tilt the memory
unit so that it is perpendicular to
the slot (
B). It should make an au-
dible click as it pops into place.
D
Attach the back plate to its origi-
nal position.
nal position.
Note
❒ A coin can be used to attach the
screws.
E
Turn on the printer's power
switch.
switch.
F
Print a configuration test sheet to
confirm that the memory unit is
properly installed.
confirm that the memory unit is
properly installed.
Reference
TS4P060E
TS4P040E
2
1
TS4P050E