Konica Minolta C250P Benutzerhandbuch

Troubleshooting

C250P

8-63

If any message other than those listed above appears, perform the operation 
described in the message.

If the problem is not corrected after the described operation is performed, 
contact your technical representative.

The finisher cannot be 
used.

Is no power supplied to the 
connector?

Check that the cord is correctly in-
serted into the connector.

The pages cannot be 
stapled.

Have the staples run out?

Replace the staple cartridge. (See 
p. 6-9.)

The pages that were fed 
out were not uniformly 
loaded and the punched 
holes or staples are in-
correctly positioned.

Is the paper curled?

Remove the paper from the paper 
tray, turn it over, and then load it 
again.

Is there a gap between the 
lateral guides in the paper 
tray and the side of the pa-
per?

Slide the lateral guides in the paper 
tray against the side of the paper so 
that there is no gap.

Even though a Punch 
setting was selected, 
holes are not punched. 
(when Punch Kit is in-
stalled on Finisher) 

Did the message “Punch 
Scrap Full.” appear?

Empty the hole-punch waste con-
tainer.