KYOCERA FS-3830N Benutzerhandbuch

Interface

1-74

Interface

This printer is equipped with a parallel interface, a USB interface and a

network interface. An optional serial interface and a second network

interface can be installed as well. Various printing environment

parameters such as the default emulation can be changed indepently on

different interfaces by using the printer’s menu selection system. Before

select the interface to apply the changes in the procedure described below.

This interface selection described below does not select which interface
data will be received from. The printer automatically selects an interface
data is received.

Parallel Interface Mode

The parallel interface mode of this printer supports a bi-directional/high-

speed mode. Normally, this interface is used under the default setting
AUTO. For details, see

Appendix B

. After setting the interface, be sure to

reset the printer or turn the power off at least once. The new setting will be

enabled thereafter.

Press the MENU key.

Press the or key repeatedly until Interface > appears. One of

the interface names shown below appears, indicating the current

interface.

Parallel (default)
USB
Network
Serial (when a serial interface board kit is installed)
Option (when a network interface card is installed)

Press the ENTER key. A blinking question mark (?) appears.

If Parallel is not displayed, press the or key repeatedly until it

is Parallel.

If you want to abandon the interface selection procedure, press the
CANCEL

key. The interface remains unchanged.

Press the ENTER key again.

Press the > key. The message display changes to the communication

mode menu.

Note

Interface
? Parallel