KYOCERA 3920DN Benutzerhandbuch

7-62

Using the Operation Panel

If an error that still allows you to continue printing occurs, the next 
received data is automatically printed after a set period of time elapses. 
For example, if the printer is shared over a network as a network printer 
and one person causes one of the above errors, after the set period of 
time elapses, the data sent from the next person is printed. The default 
setting is 

Off (Auto Error Clear disabled). 

The auto clear errors are:

Memory overflow Press GO

Print overrun Press GO

KPDL error    ## Press GO

File not found Press GO

Hard disk err ## Press GO

RAM disk error## Press GO

MemoryCard err## Press GO

Illegal Account Press GO

Exceeded Max.out Press GO

Job restricted Press GO

Account error ## Press GO

Duplex disabled Press GO

Job not stored Press GO

No multi copies Press GO

USB memory err## Press GO

For setting the auto error clear recovery time, refer to the next section 
Error Clear Timer (Setting the error clear time).

1

Press 

Z while >Timer > is displayed.

2

Press 

U or V repeatedly until >>Auto Error Clear appears. 

3

Press

 [OK]. A blinking question mark (?) appears.

4

Select 

On or Off using U or V.

5

Press

 [OK].

6

Press 

[MENU]. The display returns to Ready.

If 

Auto Error Clear is set to On and a non-fatal error (an error that 

allows printing to continue) occurs, this setting specifies the time until the 
error is recovered and printing resumes. The default time is 

30 seconds.

1

Press 

Z while >Timer > is displayed.

2

Press 

U or V repeatedly until >>Error Clear Timer appears.

3

Press

 [OK]. A blinking cursor (_) appears.

4

Press 

U or V to increase or decrease the value at the blinking 

cursor and set the desired time. The time must be set between 

5 and 

495 seconds, in 5-second increments. You can use Y and Z to 
move the cursor right and left.

5

Press

 [OK].

>>Auto Error
 Clear ? Off

>>Error Clear
 Timer   030sec.