Sharp MX-6240N Benutzerhandbuch

This function staples the loaded paper sheets into a sheaf.

1 staple in back

1 staple in front

2 Staples

This function staples each set of copies at two positions in the 

centre of paper, folds them in half, and outputs them.
(When a trimming module is installed on the saddle finisher)

For saddle stitch, it trims a side drop, offering a good-looking output 

image.

Staples each set of copies at two positions 

in the centre of paper, and folds them in half 

during output
Trims a side drop for saddle folding during 

output

Specify the trimming width within the range of 

2.0 to 20.0 mm

This function punches holes in paper. It is available for paper sizes B5R to A3.

You cannot use A3W (12" × 18") size paper, and special media such as transparency film and tab papers.

Punches holes during output

If the paper size used is A3, B4 or 11" × 17", this function can be used with saddle stitch or folding function for Z-fold.

This function folds paper in Z-fold, C-fold, or other types of shapes.
(When a saddle finisher (100-sheet stapling) is installed)

Paper can be folded in a saddle fold.

* 

The paper sizes that can be selected vary depending on the type 

of paper fold.

* 

Special media such as transparency film and tab paper cannot be

used.

Allowable paper sizes:

A3W, A3, B4, A4R, SRA3 12" × 18", 11" × 17", 

8-1/2" × 14", 8-1/2" × 11"R, 8K

The fold settings can be configured in [Detail].
Allowable paper sizes:

A3, B4, A4R, 11" × 17", 8-1/2" × 14", 8-1/2" × 11"R

This can be used with staple or punch function 

only when the A3, B4 or 11” × 17” paper is used.

Allowable paper sizes:

A4R, 8-1/2" × 11"R

Allowable paper sizes:

A4R, 8-1/2" × 11"R

Allowable paper sizes:

A4R, 8-1/2" × 11"R

Allowable paper sizes:

A4R, 8-1/2" × 11"R

This function loads previously sorted sheets and outputs multiple 

sets at once.

Enter the number of output copies  

(from 1 to 999)

Select this to set all pages as one set

* 

If this setting is enabled, set the [Number 

of Copies] to "1".

Select this to specify the number of page for 

each set

Enter a numeric value when [Manual] is 

selected.

(from 1 to 200 pages)

The output tray is automatically selected based on the output 

function you set. If Z-Fold, Half Fold, or Punch is selected, however, 

you can select the middle or offset tray for the output tray.

If you have changed the output tray, the output function may be 

deselected depending on the original output settings.

Selects the middle tray as the output tray

Selects the offset tray as the output tray