OKI 490 Benutzerhandbuch
36
Microline 490/491 User’s Guide
Busy Line, Default = SSD-
Appears only when the optional Serial Interface is installed. If
Ready/Busy protocol (factory default) is selected, you can
choose which line your system monitors for a busy signal:
Ready/Busy protocol (factory default) is selected, you can
choose which line your system monitors for a busy signal:
• SSD -9V, select SSD-
• SSD +9V, select SSD+
• DTR -9V, select DTR
• RTS -9V, select RTS
Busy Time, Default = 200 ms
Appears only when the optional Serial Interface is installed.
Sets the length of the busy signal when the Ready/Busy
protocol (factory default) is engaged,
Sets the length of the busy signal when the Ready/Busy
protocol (factory default) is engaged,
Centering Position, Default = DEFAULT
Used to limit printhead travel when printing narrow columns.
• Select Mode 1 for the narrow carriage printer.
• Select Mode 1 or Mode 2 for the wide carriage printer.
Character Set, Default = IBM Set I
Use this to switch character sets to IBM Set II
Code Page, Default = USA
Choose the Code Page character set you wish to use: USA,
Canada French, Multilingual, Portugal, Norway, BRASCII,
Abicomp, Multilingual 858, or ISO 8859-15.
Canada French, Multilingual, Portugal, Norway, BRASCII,
Abicomp, Multilingual 858, or ISO 8859-15.
CSF Bin Select, Default = Bin 1
Appears only when the optional Dual-Bin Cut Sheet Feeder is
installed. Use this to switch to Bin 2 as the default.
installed. Use this to switch to Bin 2 as the default.
CSF Type, Default = Wide
To avoid paper jams, change this setting to Narrow if you are
using the optional Cut Sheet Feeder on the wide model ML491
printer.
using the optional Cut Sheet Feeder on the wide model ML491
printer.
Diagnostic Test, Default = No
Appears only when the optional Serial Interface is installed.
Select yes to perform a diagnostic test of the serial interface.
Select yes to perform a diagnostic test of the serial interface.
DSR Signal, Default = Valid
Appears only when the optional Serial Interface is installed.
Used with the Ready/Busy protocol (factory default) to select
the way your system handles the DSR signal.
Used with the Ready/Busy protocol (factory default) to select
the way your system handles the DSR signal.