Olivetti P216 Benutzerhandbuch

Close

 

rear cover

The rear cover of the printer is open. Close the printer rear cover.

 

 

Close

 

top cover

The top cover of the printer is open. Close the printer top cover.

 

 

Duplex disabled

 

Press GO

You attempted to print with a paper size and paper type that cannot be used for 
duplex printing. Press [GO] to print onto one-side of the paper only.

 

e-MPS not stored

 

Press GO

The e-MPS job cannot be stored because RAM disk is disabled, RAM disk size is 
insufficient, hard disk is not installed, or hard disk is full. Press [GO] to print error 
report.

EF not supported 

The optional envelope feeder has been installed in this printer. The optional 
envelope feeder is not supported in the model d-Color P216.

 

Error.Power off

    F###

Turn the power switch off and then back on again. If this message still remains, turn 
the power switch off, and contact your service representative or authorized service 
center.

File not found

 

Press GO

You have attempted to print a job that is not contained in the specified virtual 
mailbox, or the specified virtual mailbox is not found.
If Auto Error Clear is set to On, printing will be automatically resumed after a preset 
period of time.

Format error

 

Hard disk

The hard disk installed in the printer is not formatted, and therefore cannot be read 
or written.

Format error

 

Memory card

The memory card inserted in the printer is not formatted, and therefore cannot be 
read or written. To format a memory card, follow the procedure in Using the 
operation panel, section of the Advanced Operation Guide.

Hard disk err ##

 

Press GO

A hard disk error has occurred. Look at the error code given in place of ## and 
refer to Storage Error Codes on page 4-11. To ignore the hard disk error, press 
[GO].

I/F  

occupied

This message is displayed when you attempt to use the printer’s operation panel to 
change the environmental settings on the interface from which data are presently 
being received.

ID error

The user ID entered for a private job, or a stored job is not correct. Check the user 
ID that you specified on the printer driver.

 

Insert the  

same 

memory card

You have inserted the wrong memory card when the Insert again message 
was displayed. Remove the wrong memory card from the printer’s memory card 
slot and insert the correct memory card. The printer again reads it from the 
beginning of the data.