MINOLTA 6100 Benutzerhandbuch
2
Remove the controller board from the printer.
Loosen two screws, one on each end of the I/O connector panel, and, using the
tab on the lower side of the connector panel, pull the controller board from the
printer.
tab on the lower side of the connector panel, pull the controller board from the
printer.
3
Position the controller board on a flat surface so the controller board lies
flat and the I/O connector panel is facing you.
flat and the I/O connector panel is facing you.
4
Remove the new controller board from its packaging.
5
Carefully remove the RAM DIMMs from the old controller board.
a
Using both thumbs, pull the
latches (one on each side of
the DIMM connector) outward.
latches (one on each side of
the DIMM connector) outward.
b
Lift the DIMM straight out of the
DIMM connector.
DIMM connector.
6
Remove any DIMMs you pur-
chased separately from their
packaging.
chased separately from their
packaging.
»
Note:
Observe the keyed side of
the DIMM to align it with the
connector.
connector.