HP (Hewlett-Packard) LCS60 Benutzerhandbuch
LCS60 Software
Configure Default Route, DNS, and SNMP
Default Route
–
dftroute*
Use the dftroute command to define the default route as shown in the example
below.
below.
The default route may be entered either as a host name or as a TCP/IP dotted
numerical address (e.g., holmes or 154.12.21.3). The host name entered as the
default router must exist in the LCS60 configuration database; use the addhost
command to add the host as necessary.
numerical address (e.g., holmes or 154.12.21.3). The host name entered as the
default router must exist in the LCS60 configuration database; use the addhost
command to add the host as necessary.
Top>Config># dftroute
CURRENT default route is . . . . . . . None
DEFAULT ROUTE FUNCTIONS
====================================================
1 ... Define the default route
2 ... Delete the default route
To select a function, enter the corresponding number
[ Type q to quit or ? for help]
==>
1
CAUTION: The default route defined here will be overridden if a
router is advertising a default route in the network.
Enter default router (name, alias, or internet address)
[ Type q to quit or ? for help ]
==>
154.12.21.3
Trying to reach host "154.12.21.3" ... OK.
CURRENT default route is ....... None
NEW
default route will be .. 154.12.21.3
Enter y to confirm NEW default route "154.12.21.3"
Enter n to reject NEW default route "154.12.21.3"
==>
y
Top>Config> #
Be sure to specify routed with the protocol command to start default route ser-
vice at boot time.
vice at boot time.
* The dftroute command cannot be run unless the TCP/IP protocol is running.
3-24
Issue 3