HP (Hewlett-Packard) LCS60 Benutzerhandbuch
Gateway
LCS60 Configuration and Connection for
Gateway Service
Gateway Service
Figure 7-1 shows an example network using gateway services.
Figure 7-1: Example Network
–
Gateway Services
Lucent Data Switch
Asynchronous Host
NAC
LCS60
LCS60
LCS200
Modem Pool
Remote
Access
Clients
Access
Clients
You can configure the LCS60 for gateway services using either the srvsetup
command or the individual commands (protocol, maxsessions, etherif). The
examples in this chapter use the individual commands.
command or the individual commands (protocol, maxsessions, etherif). The
examples in this chapter use the individual commands.
If previous configuration (for example, for TCP/IP service) has been done, some
of the steps required for configuring LCS60 for gateway services may have
already been completed (e.g., protocol, etherif). Skip the steps that have been
completed previously.
of the steps required for configuring LCS60 for gateway services may have
already been completed (e.g., protocol, etherif). Skip the steps that have been
completed previously.
Issue 3
7-1