HP (Hewlett-Packard) LCS60 Benutzerhandbuch
Administration
lcsadm Interface
ˆ
The
ˆ
is used to move back to the previous directory. Refer to Figure 8-1.
Screen 8-1: Top Directory
Top>#
Return
Commands may be abbreviated. Commands are:
config/ help
manager/
ports/ quit
service/ session/ start
stop
^
!
Top># manager
Top>Manager># ^
Top>#
Note in Screen 8-1 that the Top directory is available from the Manager directory
either by entering ˆ or top.
either by entering ˆ or top.
Initial System Setup (initsetup)
The system must be initialized before it can be used. To initialize and configure
the system before it is used the first time, the system administrator must log on
as root and run the initial setup procedures described in Chapter 3.
the system before it is used the first time, the system administrator must log on
as root and run the initial setup procedures described in Chapter 3.
Top Directory Commands
Once you log onto the LCS60, the Top
>
prompt is displayed. This indicates you
are in the LCS60 Top Directory. To display the options available from this direc-
tory, use the
tory, use the
Return
key as shown in Screen 8-1.
Note:
The directories appear on the screens followed by a slash "/".
Top is the initial directory entered when the lcsadm program is invoked. All
other directories are accessible from the Top directory by entering the directory
name. In addition to the common commands described previously, the following
commands are available from the Top directory.
other directories are accessible from the Top directory by entering the directory
name. In addition to the common commands described previously, the following
commands are available from the Top directory.
Issue 3
8-5