HP (Hewlett-Packard) LCS60 Benutzerhandbuch
Hardware
Site Preparation
EMI Considerations
The LCS60 can radiate radio frequency energy, and if not installed in accordance
with instructions, may cause interference to radio communications. This equip-
ment has been tested and found to comply with the limits for a Class A comput-
ing device pursuant to Part 15, Subpart J of FCC Regulations, which are designed
to provide reasonable protection against such interference when operating in a
commercial environment. Operation in a residential area is likely to cause
interference, in which case the user must take whatever measures may be
required to correct the interference.
with instructions, may cause interference to radio communications. This equip-
ment has been tested and found to comply with the limits for a Class A comput-
ing device pursuant to Part 15, Subpart J of FCC Regulations, which are designed
to provide reasonable protection against such interference when operating in a
commercial environment. Operation in a residential area is likely to cause
interference, in which case the user must take whatever measures may be
required to correct the interference.
Required Equipment
The LCS60 is shipped in the hardware configuration ordered, the operating
software loaded, and user documentation included. Additional equipment
required for the initial installation of an LCS60 is listed in Table 2-3.
software loaded, and user documentation included. Additional equipment
required for the initial installation of an LCS60 is listed in Table 2-3.
Table 2-3: Required Additional Equipment
_ __________________________________________________________________
Quantity Item
Description
_
__________________________________________________________________
1 Fiber
Pair
Lucent
FL2P-P-[length]* (specified in feet)
_ __________________________________________________________________
1
RS-232
Length required to connect console to
(DB25) Cable
LCS60
_ __________________________________________________________________
1
Ethernet Transceiver
Length required for connection from
(IEEE Cable)
LCS60 to Ethernet transceiver
_ __________________________________________________________________
(as reqd.)
Horizontal Shelf,
Rack mounting hardware for additional
Slide Rails, or
support; provided by rack/cabinet
support brackets
vendor.
_ __________________________________________________________________
1 (as reqd.)
ED5P183-33, G-40
Wall Mounting Kit for LCS60
_ __________________________________________________________________
1 CPM-HS
module
Node
connection
_
__________________________________________________________________
1
AWJ2
Paddleboard for the CPM-HS module
_ __________________________________________________________________
(as reqd.)
wire
18 AWG — 6 AWG wire for DC powered unit only
_ __________________________________________________________________
_ __________________________________________________________________
*
Formerly AT&T FL2P-P.
Issue 3
2-5