HP (Hewlett-Packard) LCS60 Benutzerhandbuch

LCS60 Software

—

After executing the initial setup procedures above, configure the protocols and
gateway services using the srvsetup command (Figure 3-3).

configure protocols/services

select protocols and services:
asytcp, tcpasy, etc.

assign the maximum
number of sessions to
each protocol and service

configure the ethernet
interface

atalkas

ipas

ipx

The configuration activities in the srvsetup command (protocol,
maxsessions, ipas, ipx, atalkas, etherif

) can also be accessed

individually.  Refer to Chapters 4, 5, 6, and 7 for examples of individual
commands.

Perform the following steps to configure the protocols and gateway services for
your LCS60.  (You should have already done an initsetup as described
previously.)

Enter srvsetup at the Top

>

>

# prompt to start the

protocol/service setup routine.

Follow the menus in the srvsetup; they will guide you through the
items essential for your configuration (refer to Figure 3-3).  A sample
srvsetup

session is presented in the screens that follow.

Refer to the Glossary at the end of this document for definitions of
parameter values.