Fujifilm MP-300 Benutzerhandbuch

P

rin

tin

g

Printing

  Remove the photo pack.

When the printer runs out of fi lm, the 
POWER button goes dark and “0” 
appears on the fi lm counter.

x Each time a new image is sent to the 

printer, or each time the POWER or 
REPRINT button is pressed, the fi lm 
counter blinks (5 times) to indicate 
that the printer is out of fi lm.

  Check that the film counter 

shows “0”.

1

2

●

●

    Do not take out a photo pack until using up all 10 fi lms.

zThe films will be exposed.
z The film counter is reset when a photo pack is removed and may not 

show the correct number of remaining films.

●

●

    Take care not to load a used photo pack.

z Always check the unused check window on the photo pack before 

replacing the fi lm.

z If you mistakenly load a used photo pack, the printer will run normally 

but will not print images.

Used

Unused

On an unused photo 
pack, the unused check 
window is closed all the 
way to the “

■” mark.

On a used photo pack, 
the unused check 
window is open to the  
“

▲” mark.

If the printer runs out of fi lm while it is 
printing a specifi ed number of images, 
the POWER button and the PictBridge 
lamp blink rapidly and “0” appears on 
the fi lm counter.

  Check that the film counter 

shows “0”.

x  When you replace the fi lm while printing a specifi ed number of prints, leave the 

printer turned on. Turning the printer off while replacing the fi lm will delete the 
digital camera print settings.

  Load a new photo pack.

(P.22)

x  Leave the printer turned on.

  Restart printing of the 

specified images.

Lit

Lit

Lit

Lit

1       2

3       4

When the POWER button and 
PictBridge lamp stays lit, press the 
REPRINT button.

◆

◆

When the fi lm runs out while printing