Zebra Technologies ZM400201101L0T Benutzerhandbuch
53
Operations
Adjust Printhead Pressure
3/27/07
ZM400/ZM600 User Guide
79695L-001 Rev. A
Adjust Printhead Pressure
You may need to adjust printhead pressure if printing is too light on one side, if you use thick
media, or if the media drifts from side to side during printing.
media, or if the media drifts from side to side during printing.
. The ZM400 pressure adjustment dials have four possible settings designated by
blocks of increasing size embossed on the print mechanism. The smallest block (fully
counterclockwise) is considered position 1, and the largest block (fully clockwise) is
considered position 4. The ZM600 dials have seven settings instead of four.
counterclockwise) is considered position 1, and the largest block (fully clockwise) is
considered position 4. The ZM600 dials have seven settings instead of four.
Figure 10 • Printhead Pressure Adjustment Dials
To set printhead pressure, complete these steps:
1.
to select the initial dial settings for your media, depending on
which printer you have.
1
Outside dial
2
Inside dial
1
2
Table 10 • ZM400 Printhead Pressure
Media Width
Inside Dial
Outside Dial
1 in. (25.4 mm)
3
1
2 in. (51 mm)
4
1
3 in. (76 mm)
3
2
3.5 in. and up (89 mm and up)
3
3