Zebra Technologies ZM400201101L0T Benutzerhandbuch

Configuration
Setup Mode

79695L-001 Rev. A

ZM400/ZM600 User Guide

3/27/07

After you have installed the media and ribbon and the Power-On Self Test (POST) is complete, 
the control panel displays 

PRINTER READY

. You may now set printer parameters for your 

application using the control panel display and the buttons directly below it. If it becomes 
necessary to restore the initial printer defaults, see 

Press 

SETUP/EXIT

. 

Press 

PLUS (+)

 or 

MINUS (–)

 to scroll through the parameters.

Press 

SELECT

 to select and deselect the parameters.

Certain printing conditions may require that you adjust printing parameters, 

such as print speed, darkness, or print mode. These conditions include (but are not 
limited to):

• printing at high speeds

• peeling the media

• the use of extremely thin, small, synthetic, or coated labels

Because these and other factors affect print quality, run tests to determine the best 
combination of printer settings and media for your application. A poor match may limit print 
quality or print rate, or the printer may not function properly in the desired print mode.

 If the printer is operating on an IP network, you can change the printer’s parameters 

in these additional ways:

• with ZebraLink™ WebView (ZebraNet 10/100 PrintServer, PSII, or Wireless Print Server 

required). For information, see the appropriate print server user guide.

• with the SetWLAN configuration utility or the ZebraNet Bridge Wireless Setup Wizard 

(ZebraNet Wireless Print Server required). For information, see the ZebraNet Wireless 
Print Server User Guide.