Zebra Technologies PrintServer Benutzerhandbuch

Internal PSII

PrintServer II User and Reference Guide 

25

 

.

4. Through the mounting slot, insert the ribbon cable and 

PSII

.

5. Fold the cable and the ferrite bead back over the mounting bracket, and connect the 

ribbon cable connector into the keyed Interface Data Cable Connector (J4) on the 
main logic board. 

Confirm that the connector is properly seated and that pin 1 of the Interface Data 
Cable Connector is connected to pin 1of J4. 

6. Secure the 

PSII

 interface board in place with the cover plate screws that you 

removed early in this step sequence.

7. Confirm that all small cable connectors are tight.

8. Reinstall the PAX-Series PCB access panel or the left side-panel of the XiII and 

XiIII-Series printers that you removed earlier in this step sequence.

9. This kit includes a label printed with the Ethernet MAC hardware address for the 

PSII

. Remove the backing from the label and affix it to the back of the printer.

10. Reconnect the AC power cord and turn the printer power on.

Note • The parallel port on the back of the printer is not operational when the 
internal 

PSII

 is installed. The hardware of the 

PSII

 mounting bracket covers the 

parallel port.