Zebra Technologies PrintServer Benutzerhandbuch

Assigning an IP Address

PrintServer II User and Reference Guide 

41

3. From the Print Server Configuation>TCP/IP tab, in the Default GateWay text-box, 

type in your default gateway.

4. Confirm it is accurate, and click OK.

These steps can be used with all printers. However, the LCD instructions are for XiIII 
units. 

1. Power on the printer and allow two minutes for all systems to complete self test. If 

you do not have a network cable in the port, the print server prints configuration 
label when it is ready.

2. On the printer front panel, press SETUP/EXIT.

3. On the printer front panel, press PREVIOUS twice until you reach the network 

settings menu items. 

4. You can edit any of the following network setting in order to communicate with 

PSII

 in your network environment.

• default gateway (default setting of 000.000.000.000) 

• subnet mask (default setting 255.0.0.0) 

• ip address (if initial default setting is 0.0.0.0, after two minutes this defaults to 

198.102.102.254 or 192.168.254.254 - depends on firmware version) 

• ip protocol (gleaning only, rarp bootp, dhcp, dhcp and bootp, all) 

• ip resolution (dynamic, permanent) The printer menu item IP RESOLUTION 

must be set to PERMANENT if attempting to assign the IP Address from the 
front panel

Important • Your 

PSII

 must have firmware 6.3 and higher and your Zebra printer 

must have firmware x.10 or higher with an LCD. 

Important • To change any of these settings, you need to use the default password: 
1234

.