Zebra Technologies R170XiTM Benutzerhandbuch
Front Panel Controls
Front Panel LCD
23063L-003 Rev. 2 12/23/04
R110Xi/R170Xi User Guide
61
DEFAULT
GATEWAY
2
Default Gateway
This parameter allows you to select the IP address that the network traffic is routed
through if the destination address is not part of the local network.
This parameter allows you to select the IP address that the network traffic is routed
through if the destination address is not part of the local network.
1.
Press the left oval to move to the next digit position.
2.
Press the right oval to increase the value of the digit.
MAC ADDRESS
1,3
MAC Address
This parameter cannot be changed through the front panel.
This parameter cannot be changed through the front panel.
ESSID
1,3
ESSID
This parameter cannot be changed through the front panel.
This parameter cannot be changed through the front panel.
AUTH. TYPE
1,3
Authentication Type
Default: OPEN
Selections: OPEN, SHARED
Default: OPEN
Selections: OPEN, SHARED
LEAP MODE
3,4
An encryption method that is available with some wireless cards. Set the LEAP user
name and password through the printer web pages.
Accepted Values: ON, OFF
Default Value: OFF
name and password through the printer web pages.
Accepted Values: ON, OFF
Default Value: OFF
ENCRYPTION
MODE
1,3
Encryption Mode
Default: OFF
Selections: OFF, 40-BIT, 128-BIT
Default: OFF
Selections: OFF, 40-BIT, 128-BIT
ENCRYPTION
INDEX
1,3
Encryption Index
Default: 1
Selections: 1, 2, 3, 4
Default: 1
Selections: 1, 2, 3, 4
RESET
NETWORK
NETWORK
2,3
Reset Network
This option resets the wireless card and the print server when the wireless option is
running. Selecting this option has no effect when the wireless option is not running,
when there is no card inserted, or when the wireless password is anything other than
the default (zero).
This option resets the wireless card and the print server when the wireless option is
running. Selecting this option has no effect when the wireless option is not running,
when there is no card inserted, or when the wireless password is anything other than
the default (zero).
1.
Press the right oval to select
YES
.
The LCD prompts
ARE YOU SURE?
.
• Press the left oval to select
NO
to cancel the request.
• Press the right oval to select
YES
and reset the network.
Table 8 • Print Server LCD Displays (Continued)
Parameter
Action/Explanation
1 Appears only when the ZebraNet Wireless Print Server is installed.
2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to
address 192.168.254.254.
address 192.168.254.254.
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
card supports LEAP.