Zebra Technologies Z6Mplus Benutzerhandbuch
72
Z4Mplus/Z6Mplus User Guide
13163L Rev. 3 5/20/2004
Configuration
Configuration and Calibration LCD Displays
ZebraNet
®
Wired and Wireless Print Server LCD Displays
display only if you have the ZebraNet PrintServer II,
10/100 PrintServer, or Wireless Print Server installed.
Table 10 • Print Server LCD Displays
LCD
Explanation
IP PROTOCOL
1
IP Protocol
Allows either the user (permanent) or the server (dynamic) to select the IP address.
If a dynamic option is chosen, this selection determines the method(s) by which the
print server (wired or wireless) receives the IP address from the server.
• Press the right or left oval to display other choices.
Default: ALL
Selections: ALL, GLEANING ONLY, RARP, BOOTP, DHCP, DHCP AND BOOTP,
PERMANENT
Note •
Allows either the user (permanent) or the server (dynamic) to select the IP address.
If a dynamic option is chosen, this selection determines the method(s) by which the
print server (wired or wireless) receives the IP address from the server.
• Press the right or left oval to display other choices.
Default: ALL
Selections: ALL, GLEANING ONLY, RARP, BOOTP, DHCP, DHCP AND BOOTP,
PERMANENT
Note •
Use of GLEANING ONLY is not recommended when the Wireless Print
Server is installed.
IP ADDRESS
1
IP Address
This parameter allows you to select the IP address if PERMANENT was chosen in
IP PROTOCOL. (If a dynamic option was chosen, the user cannot select the address.)
This parameter allows you to select the IP address if PERMANENT was chosen in
IP PROTOCOL. (If a dynamic option was chosen, the user cannot select the address.)
1.
Press the left oval to move to the next digit position.
2.
Press the right oval to increase the value of the digit.
SUBNET MASK
1
Subnet Mask
This parameter selects the part of the IP address that is considered to be part of the
local network. It can be reached without going through the default gateway.
This parameter selects the part of the IP address that is considered to be part of the
local network. It can be reached without going through the default gateway.
1.
Press the left oval to move to the next digit position.
2.
Press the right oval to increase the value of the digit.
DEFAULT
GATEWAY
1
Default Gateway
This parameter allows you to select the IP address that the network traffic is routed
through if the destination address is not part of the local network.
This parameter allows you to select the IP address that the network traffic is routed
through if the destination address is not part of the local network.
1.
Press the left oval to move to the next digit position.
2.
Press the right oval to increase the value of the digit.
MAC ADDRESS
2,3
MAC Address
This parameter cannot be changed through the front panel.
This parameter cannot be changed through the front panel.
ESSID
2,3
ESSID
This parameter cannot be changed through the front panel.
This parameter cannot be changed through the front panel.
1 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to
address 192.168.254.254.
address 192.168.254.254.
2 Appears only when the ZebraNet Wireless Print Server is installed.
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
card supports LEAP.