Zebra Technologies Z6Mplus Benutzerhandbuch
Printer Operation
Load Roll Media
13163L Rev. 3 5/20/2004
Z4Mplus/Z6Mplus User Guide
33
Rewind/Peel-Off Mode
The Rewind option must be installed to use this mode. The option is shown in
Figure 21
.
Figure 21 • Rewind/Peel Mode
To load media in Rewind/Peel-Off Mode, complete these steps:
1.
Press the printhead open lever. The printhead assembly springs up.
2.
Flip down the media supply guide.
3.
Slide the media guide as far from the main frame as possible.
1
Printhead Assembly
2
Transmissive Sensor
3
Label Supply Guide
4
Label Supply Hanger
5
Rewind Spindle
6
Rewind Label Guide
7
Thumbscrew
8
Dancer
9
Label Guide
10
Media Alignment Spindle
11
Printhead Open Lever
12
Peel Assembly
13
Label
14
Rewind Base Assembly
15
Peel Lever
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Caution • Ensure that the printhead is fully open and engaged in the upright position.
If you fail to latch the printhead, it could fall on your hand during the procedure.
If you fail to latch the printhead, it could fall on your hand during the procedure.