Zebra Technologies Z4Mplus Benutzerhandbuch
86
Z4Mplus and Z6Mplus User Guide
Routine Care and Adjustments
Cleaning Procedures
Cleaning Procedures
Specific cleaning procedures are provided on the following pages. Below is a
recommended cleaning schedule.
recommended cleaning schedule.
.
Area
Method
Interval
Printhead
Solvent*
Direct Thermal Mode: After
every roll of media (or 500 feet of
fanfold media).
every roll of media (or 500 feet of
fanfold media).
Thermal Transfer Mode: After
every roll of ribbon or three rolls of
media.
every roll of ribbon or three rolls of
media.
These intervals are intended as
guidelines only. You may have to
clean more often, depending upon
your application and media.
guidelines only. You may have to
clean more often, depending upon
your application and media.
Platen roller
Solvent*
Media sensors
Air blow
Ribbon sensor
Air blow
Media path
Solvent*
Ribbon path
Solvent*
Pinch roller. (Optional peel-
off option required. Refer to
off option required. Refer to
.)
Solvent*
Cutter
Module
Module
If cutting
continuous,
pressure-sensitive
media
continuous,
pressure-sensitive
media
Solvent*
After every roll of media (or more
often, depending upon your
application and media).
often, depending upon your
application and media).
If cutting tag stock
or label liner
material
or label liner
material
Solvent*
and air
blow
and air
blow
After every two or three rolls of
media.
media.
Tear-off/peel-off bar
Solvent*
Once a month.
Take label sensor
Air blow
Once every six months.
* Zebra recommends using the Preventive Maintenance Kit, Part Number 47362 or a solution of 90% Isopropyl and 10%
deionized water)
deionized water)
Note • Zebra Technologies Corporation will not be responsible for damage caused
by the use of cleaning fluids on the Z4Mplus/Z6Mplus printer.
by the use of cleaning fluids on the Z4Mplus/Z6Mplus printer.