Zebra Technologies Z4Mplus Benutzerhandbuch

40

 

Z4Mplus and Z6Mplus User Guide

Load Roll Media

Cutter Mode requires that the cutter be installed.

1. Press the printhead open lever. The printhead assembly springs up.

2. Flip down the media supply guide.

3. Slide out the media guide as far from the printer frame as possible.

4. Place the roll of media on the media supply hanger and orient the media properly.

5. Flip up the media supply guide. 

6. Slide in the media supply guide until it touches, but does not restrict, the edge of 

the roll.

7. Feed the media under the dancer, through the slot in the transmissive sensor, under 

the ribbon sensor, and through the cutter module.

8. Ensure that the media is against the back of the transmissive sensor. Then, slide in 

the media guide until it touches, but does not restrict, the edge of the media.

9. Close the printhead assembly.

10. The printer is paused (the Pause light is on), press 

 to enable printing.

Caution • Ensure printhead is fully open and engaged in the up position. Failure to 
latch in the up position could result in the printhead falling on your hand during the 
procedure.