Zebra Technologies 170PAX2TM Benutzerhandbuch
Parameter
Controlled by
LCD Adjust
Configuration
Modes Enabled
ZPL
Modes Disabled
ZPL
Resolution
Fixed (head type switch)
Socket 1 ID
Fixed (option EPROMS)
Firmware
Fixed (code EPROMS)
Configuration
Configuration
Memory
Fixed (SIMM size and 1 MB standard)
B: Memory
Fixed (option card)
J12 Interface
Fixed
J11 Interface
Fixed
J10 Interface
Fixed
J9 Interface
Fixed
J8 Interface
Fixed
J7 Interface
Fixed
Twinax/Coax ID
ZPL
Communications Diagnostics Test
The following test cannot be performed until all configuration and calibration parameters have been
set. For information, refer to “Configuration and Calibration.”
This test is performed via the control panel. Refer to
This test is performed via the control panel. Refer to
“Setting the Communications Mode” in
“Configuration and Calibration.” A typical printout from this test is shown in Figure 19.
NOTE: This label will be inverted when printed.
46
170PAX2-Series User’s Guide
Troubleshooting
Figure 19. Results of Communications Diagnostic Test