Zebra Technologies 1050020011570 Benutzerhandbuch
115
Routine Maintenance
Clean the Cutter
6/30/06
105SL User Guide
11342L-001 Rev. A
Clean the Cutter
If the cutter is not cutting the labels cleanly or if it jams with labels, clean the cutter.
To clean the cutter, complete these steps:
1.
Turn off (O) the printer.
2.
Unplug the power cord.
3.
Using the swab from the Preventive Maintenance Kit (part number 47362), clean the
stationary cutter blade with solvent. In place of the Preventive Maintenance Kit, you may
use a clean swab dipped in a solution of isopropyl alcohol (minimum 90%) and deionized
water (maximum 10%). Allow the solvent to evaporate.
stationary cutter blade with solvent. In place of the Preventive Maintenance Kit, you may
use a clean swab dipped in a solution of isopropyl alcohol (minimum 90%) and deionized
water (maximum 10%). Allow the solvent to evaporate.
If this does not remove label fragments and adhesive, contact an authorized service
technician.
technician.
4.
Turn on (I) the printer.
Caution •
For personnel safety, always power off and unplug the printer before performing
this procedure.
Caution •
The cutter blade is sharp. Do not touch or rub the blade with your fingers.