Zebra Technologies RW 420 Benutzerhandbuch

RW Series User Guide

Zebra Value Radio, 802.11b

The following section only applies when the Zebra Value Radio, 802.11b (with FCC ID: I28MD-ZLAN11B) is

installed in a RW series printer. The FCC ID number is on the serial number label on the back of the printer

and can be read with the module installed. Other than conditions specified elsewhere in this manual, only

one of the radio options can be installed in the printer at one time and the antenna used for these transmit-

ters must not be co-located or must not operate in conjunction with any other antenna.

Caution • The radiated output power of this internal 802.11b radio is far

below the FCC radio frequency exposure limits. Nevertheless, this radio

must be used in such a manner that the antenna is 2.5 cm. or further

from the human body. The radio and antenna are mounted internally

in this printer such that when the printer is worn with the back of the

printer against the body and the front of the printer (where paper exits)

away from the body, then the 2.5 cm distance between the antenna and

the users body will be met. Do not use the printer in an unauthorized

manner.

European Regulatory Information for this Radio

Note: -Member states in the EU with restrictive use for this device are
crossed out!
This device is also authorized for use in all EFTA member states (CH, IS, LI, NO)

Important Notice:
This device is a portable RF printer intended
for commercial and industrial use in all EU and
EFTA member states except in France where
restrictive use applies.