Zebra Technologies 105SL Benutzerhandbuch
Troubleshooting
Print Quality Problems
11342L Rev. 8 6/4/2004
105SL User Guide
83
Light, consistent
vertical lines running
through all of the
labels
vertical lines running
through all of the
labels
The printhead or platen roller is
dirty.
dirty.
Clean the printhead according to the instructions in
Caution • The printhead is hot and can
cause severe burns. Allow the printhead
to cool.
cause severe burns. Allow the printhead
to cool.
Electrostatic Discharge Caution •
Observe proper electrostatic safety
precautions when handling any static-
sensitive components such as circuit
boards and printheads.
Observe proper electrostatic safety
precautions when handling any static-
sensitive components such as circuit
boards and printheads.
Intermittent creases
on the left and right
edges of the labels
on the left and right
edges of the labels
There is too much toggle
pressure on the printhead.
pressure on the printhead.
Reduce the toggle pressure. See
Wrinkled Ribbon
The ribbon is not loaded
correctly.
correctly.
Load the ribbon correctly. See
.
The darkness setting is incorrect. Set the darkness to the lowest possible setting for
good print quality. See
.
Incorrect printhead pressure or
balance.
balance.
Set the pressure to the minimum required for good
print quality. See
print quality. See
.
The media is not feeding
correctly. It is “walking” from
side to side.
correctly. It is “walking” from
side to side.
Make sure that the media guide and media supply
guide touch the edge of the media.
guide touch the edge of the media.
Table 12 • Print Quality Problems (Continued)
Problem
Possible Cause
Recommended Solution