Zebra Technologies 105S Benutzerhandbuch
24
Zebra S-Series User’s Guide
7UDQVPLVVLYH6HQVLQJ0RGH
In transmissive sensing mode, a sensor detects a light shining through a
web, notch, or hole in non-continuous media. In this way, the printer
determines the position of the label/tag.
web, notch, or hole in non-continuous media. In this way, the printer
determines the position of the label/tag.
%ODFN0DUN6HQVLQJ0RGH
In black mark sensing mode, a sensor detects the black marks that are
printed on the back of the label liner for each label. The label length and
top of label are determined by the location of the black mark.
printed on the back of the label liner for each label. The label length and
top of label are determined by the location of the black mark.
0HGLD7UDQVSRUW0RGHV
7HDU2II0RGH
When the media is in the rest (idle) position, the webbing between labels is
over the tear-off/peel-off bar. To print a label, the printer first backfeeds
the media until the start of the label is directly under the printhead and then
prints the entire label.
over the tear-off/peel-off bar. To print a label, the printer first backfeeds
the media until the start of the label is directly under the printhead and then
prints the entire label.
After a label is printed, the media feeds forward until the end of the label is
past the tear-off/peel-off bar. This label position is determined by
commands sent to the printer from the host computer or by front panel
adjustments.
past the tear-off/peel-off bar. This label position is determined by
commands sent to the printer from the host computer or by front panel
adjustments.
When a quantity of labels is required, a format for printing a batch of
labels can be sent to the printer. Once a label is printed, the media feeds
forward to the start of the next label and printing continues. In this way,
the printer prints the batch and stops when it reaches the quantity required.
labels can be sent to the printer. Once a label is printed, the media feeds
forward to the start of the next label and printing continues. In this way,
the printer prints the batch and stops when it reaches the quantity required.
When a quantity of individual labels is required, the format for printing a
batch of labels can still be sent to the printer. The operator can use the
PAUSE key to cycle the printing one label at a time. The operator can then
tear off each label before printing the next one.
batch of labels can still be sent to the printer. The operator can use the
PAUSE key to cycle the printing one label at a time. The operator can then
tear off each label before printing the next one.