Zebra Technologies R110XiTM Benutzerhandbuch

^RT

23063L-003 Rev. 2 12/23/04

R110Xi/R170Xi User Guide

91

Description  This command tells the printer to read the current RFID tag data. The data can 
be sent back to the host via the 

^HV

 command.

^RT#,b,n,f,r,m,s

The following table identifies the parameters for this format.

It is recommended that you use the 

^RF

, 

^RM

, and 

^RR

 commands rather than the 

^RT

 command. The 

^RT

 command is provided only for backward-compatibility with label 

formats that were developed for other Zebra RFID printers.

#

= number to be 

assigned to the field

Accepted values: 0 to 9999
Default value: 0

b

= starting block number Accepted values: 0 to n, where n is the maximum number of blocks for the tag.

Default value: 0

n

= number of blocks 

to read*

Accepted values: 1 to n, where n is the maximum number of blocks for the tag 
type minus the starting block number. For example, if the tag has 8 blocks 
(starting with block 0) and you start with block 6, n can be 2. This would return 
block 6 and block 7 information.
Default value: 1

f

= format

Accepted values: 
• 0  (ASCII)
• 1 (Hexadecimal)
Default value: 0

r

= number of retries

Changes the number of times that the printer attempts to read a particular block 
of a single RFID tag. (Same retry rules as the 

^RR

 command.)

Accepted values: 0 to 10
Default value: 0

m

= motion

Enables or disables RFID motion for the current field.
Accepted values: 
• 0 (Feed label after writing.)
• 1 (No feed after writing. Other ZPL may cause a feed.)
Default value: 0

s

= special mode*

For EPC Class 1 (Alien reader) only. Not applicable for EPC class 0.
Default value: 0
Accepted values: 
• 0 (Do not read if mismatched checksum.)
• 1 (Read even if mismatched checksum.)

*Not applicable for R110Xi/R170Xi