Zebra Technologies 79695L-002 Benutzerhandbuch
109
Routine Maintenance
Cleaning Procedures
6/6/08
Z Series
®
/RZ™ Series User Guide
79695L-002 Rev. A
4.
. Using the swab from the Preventive Maintenance Kit (part number 47362),
wipe along the upper cutting surface (
1
) and the cutter blade (
2
). In place of the
Preventive Maintenance Kit, you may use a clean swab dipped in a solution of isopropyl
alcohol (minimum 90%) and deionized water (maximum 10%). Allow the solvent to
evaporate.
alcohol (minimum 90%) and deionized water (maximum 10%). Allow the solvent to
evaporate.
Figure 18 • Cleaning the Cutter Module
5.
Replace the cutter shield.
6.
Plug the printer into its power source, and then turn on (I) the printer.
The lower cutter blade returns to its correct operating position.
7.
If the cutter continues to perform unsatisfactorily, contact an authorized service
technician.
technician.
1
2