Zebra Technologies GX430D Benutzerhandbuch

Getting Started
Attaching Power

980611-001 Rev. C

GX420d™ / GX430d™ User Guide

8/4/10

Make sure the printer’s power switch is in the off position (down).

Insert the AC power cord into the power supply.

Plug the other end of the cord into an appropriate AC electrical outlet. Note: The active 
power light will go on if power is on at the AC outlet.

Insert the power supply’s power connector into the printer’s power receptacle.

Set up your printer so that you can handle the power cord easily if needed. To 

make certain the printer cannot carry electrical current, you must separate the power cord 
from the power supply receptacle or AC electrical outlet.

Never operate the printer and power supply in an area where they can get wet.  

Serious personal injury could result!

Note • Ensure the appropriate power cord with a three (3) prong plug and an IEC 60320-C13 
connector are used at all times. These power cords must bear the relevant certification mark of 
the country in which the product is being used.