Hauppauge MediaMVP 1004 Benutzerhandbuch

Installing the MediaMVP software

There are two parts to the MediaMVP operation: the 

which runs on the MediaMVP device, and

the 

which runs on a PC. Both of these are automatically installed from the 

The 

runs on the Linux operating system. When you turn on MediaMVP, you will see a

screen on your TV set, which is the inital screen created by MediaMVP’s Linux system. After this screen, the MediaMVP
device loads the 

from the PC.

The 

is installed on any PC which is on the same subnet as the MediaMVP. This means

that the PC should be connected to the same router or hub as the MediaMVP.  The 

loads the 

onto the MediaMVP after it is powered on, and then provides all of the informa-

tion you see on your TV set after the MediaMVP is running.

for the MediaMVP device to operate, the PC must be turned on, running Windows, and running the MediaMVP PC

Server application. Also, the PC needs to be on the same network subnet as the MediaMVP. 

. 

Note: the MediaMVP application is loaded each time the MediaMVP has its power turned on. If you download a new version
of MediaMVP for the Hauppauge web site, you need to disconnect the power to the MediaMVP, then reconnect, to allow the
new application to be loaded.

Installation of the MediaMVP software:

Step 1: To install the MediaMVP software, simply run the 

program from the 

. After run-

ning setup, the 

is automatically started.

Step 2: Connect the MediaMVP to a TV set, plug the wall mounted power supply into a wall outlet and the power plug into

the MediaMVP.  The MediaMVP will display the following screens:

- MediaMVP: checking Ethernet connectivity

- MediaMVP: contacting DHCP server

- MediaMVP: contacting MediaMVP Bootserver

- MediaMVP: Loading application

- MediaMVP: Starting application

- MediaMVP: Contacting servers

You will then see the MediaMVP Main menu.

Connecting the MediaMVP to your home network through a
router, switch or hub

Using a standard 

(the Ethernet cable supplied or any Ethernet cable of length less than 300 feet),

plug one end into the 

, and the other end of the Ethernet cable into a 

,

or 

. You can use 

or 

router/switches. If you are using your own cables, use 

for best results.

When you have made this con-
nection, boot your PC and run
the 

.

This should take a few minutes
and is automatic.

After the 

has been run, 

by plugging in the

power adapter.

The MediaMVP will display a
message for about 1 minute
“

”. After

about a minute, it will find the
PC which it is connected to and
display a message “

”. 

A few seconds later the