Brother HL-800 Benutzerhandbuch

USER’S GUIDE

3-4

The printer has the following test print mode. Follow these steps:

1. Make sure that the top cover is closed.

2. Hold down the switch and turn on the 

 switch. Keep the

 depressed until the 

 lamp comes on.

The 

 lamp lights to indicate that the printer is in the test print

mode.

3. Press the 

 again to execute the test print or hold down the

 to select another option and release the 

 to execute the

selected option.

The test print mode varies depending upon the printer model as
follows:

Test sample page The printer prints a test sample page.

The printer returns to the ready status after
printing.

Print Config  & Print
Fonts I

The printer prints the current configuration of
the printer and a list of the internal fonts.
The printer returns to the ready status after
printing. (HL-1040/1050 only)

Factory Reset The printer is restored to the factory setting and

permanent fonts and macros are cleared.
The printer returns to the ready status after
printing. (HL-1040/1050 only)

Hex Dump Print The printer can print data as hexadecimal values,

so that you can check data errors and problems.
To exit from this mode, you have to turn off the
printer. (HL-1040/1050 only)