Fujitsu 500 Benutzerhandbuch
49
9
Connect the flat cable.
Connect the flat cable properly in accordance with the type of the internal option installed.
To use a hard disk drive supporting Ultra DMA/66 or Ultra DMA/100, connect it to the slave of the
primary IDE.
Connect the flat cable properly in accordance with the type of the internal option installed.
To use a hard disk drive supporting Ultra DMA/66 or Ultra DMA/100, connect it to the slave of the
primary IDE.
To install a magneto-optical disk drive or a hard disk drive other than the above, disconnect the
master secondary cable from the CD-ROM drive and connect it to the magneto-optical disk drive
or hard disk drive.
Connect the CD-ROM drive to the slave of the secondary IDE.
master secondary cable from the CD-ROM drive and connect it to the magneto-optical disk drive
or hard disk drive.
Connect the CD-ROM drive to the slave of the secondary IDE.
Connect the option here to
configure it as the master.
configure it as the master.
Connect the option here to
configure it as a slave.
configure it as a slave.
To the motherboard
Pin 1
Blue or red line
MASTER
SLAVE
Black
Gray
Blue