Epson 286 PLUS Benutzerhandbuch

Before you perform the following steps, be sure that you have set
the jumpers on any hard disk drive(s) that you’ll be using. (If

not, see “Setting the Hard Disk Drive Jumpers” on page B-4 for

instructions.)

If you are adding a 3M-inch diskette drive or hard disk drive, you

need to make sure that 51/4-inch metal mounting frames are

attached to the drive so it fits properly in the drive bay. Epson

3 1/2-inch drives come with mounting frames already installed. If

your drive did not come with frames installed, follow the

instructions in the manual that came with it to attach them.

The figures in this section show a diskette drive, but you can use

the same instructions to install a hard disk drive.

Follow these steps to install a disk drive:

1.

If you are installing a 51/4-inch diskette drive, turn it so that
the diskette release latch is above the diskette slot.

If you are installing a 31/2-inch diskette drive, turn it so that

the diskette release button is on the right and the drive light

is on the left.

If you are installing a hard disk drive, turn it so that the side

with the components is facing down.

Installing and Removing Disk Drives

B-33