Epson 286 PLUS Benutzerhandbuch

This section describes how to reinstall your hard disk drive in

the vertical mounting position. The following illustrations show

the subassembly installed inside the computer with the front

panel attached. However, if your subassembly is out of the

computer you can install the drive in the manner described
below. Follow these steps:

1.

Pick up the hard disk drive and hold it above the right side

of the subassembly with the mounting plate facing the
subassembly, as shown below.

Notice that there are two tabs facing downward on the

bottom of the mounting plate. These tabs will fit into two
slots in the right side of the subassembly.

Installing and Removing Disk Drives

B-41