Epson Equity II Benutzerhandbuch

Contact your Epson dealer to obtain a new lithium battery and fol-

low these steps to install it:

Follow the instructions in Chapter 4 to remove the main unit’s cover.

Locate the battery just behind the front panel on the side with the

Epson Equity II logo.

To disconnect the battery, grip the brown battery connector on the

main system board and pull it straight up.

Remove the screw on the plate that secures the battery and set the

screw and the plate aside.

Lift out the battery.

Insert the new battery and replace the cover plate and screw.

To connect the new battery, insert the new battery’s connector into

the main system board.

Replace the main unit’s cover as described in Chapter

After you install a new battery, you need to run the MS-DOS SETUP

program to re-enter information about your system configuration and

reset the correct date and time.