Epson Y14499113001 Benutzerhandbuch

With the option card properly installed or removed, the last step is to

replace the cover of the main unit:

1. With the back of the main unit facing you, position the cover over the

computer with the side feet to the left of the main unit and the front edge
pointing slightly downward.

2. Lower the cover onto the bottom half of the case, as shown in Figure

3-6, making sure that the bottom edges fit inside the case. At the same
time, slide the front edge beneath the top edge of the front panel. Finally,
lower the back of the cover so that it is in position.

Figure 3-6. Replacing the cover

3. Secure the cover by replacing the screws on both sides of the main unit.

Snap the plastic inserts into the side feet.

4. Replace the back panel and the three screws along the top edge.

5. Return the computer to its original position and reconnect it to the

monitor, the keyboard, and any other peripherals you have.

6. Check to make sure the power switch is off. Reconnect the power cable

to the back of the main unit and to an electrical outlet. Change the DIP
switches if necessary.

3-6