Fujitsu FLASH-CAN-100 Benutzerhandbuch

Change even page title here

Chapter 5 Configuration of the Evaluation-Board

UG-900001-32

- 10 -

5 Configuration of the Evaluation-Board

The board is configured to work with the MB90F598 microcontroller.

In order to set up the board follow these steps:

1. disconnect power supply disconnected !

2. Set jumper JP1 to provide Vcc, i.e. 5V to the board

3. If case one is connecting this board to an emulator, it is recommended to set jumper JP2

in order to provide 3.7V to the internal core.

4. Please set the mode pins 1-3 on S3 according to your MCU operating mode. ON stands

for 0 and OFF for 1. E.g. MB90F598 all switches to OFF except no. 3.

5. Adjust both potentiometers (P1, P2) clockwise to their end position.

(Check that Pin 8 of U4 and Pin 8 of U5 are grounded.)

6. Select the appropriate CAN interface for the microcontroller you are using by setting

jumper JP3-JP6. Note that Pixx on the silk plot stands for Pinxx, i.e. the pin number.
E.g. for the MB90F598, set JP3 and JP4 to connect Pin 2 and 3 in order to connect to
MCU Pins 74 and 75, respectively.

CAN0

CAN1

CAN2

Target
Series

RX0

TX0

RX1

TX1

RX2

TX2

MB90425

Pin 75

Pin 74

n.a.

Pin 72

Pin 71

MB90440

Pin 74

Pin 73

Pin 76

Pin 75

(Not supported by

Jumper 3-6 !)

MB90470 n.a. n.a. n.a. n.a. n.a. n.a.

MB90540

Pin 74

Pin 73

Pin 76

Pin 75

n.a.

MB90545

Pin 74

Pin 73

n.a.

MB90550 n.a. n.a. n.a. n.a. n.a. n.a.

MB90583 n.a. n.a. n.a. n.a. n.a. n.a.

MB90590

Pin 75

Pin 74

Pin 97

Pin 98

n.a.

MB90595

Pin 75

Pin 74

n.a.

Table 1: Microcontroller pin-number of the CAN-interface