Omron BU3002SW Benutzerhandbuch

32

2. Installation and connection

Does the status indicator appear as one of those shown below?

If not the same as one of those shown above:

➜ Operation is abnormal. Check the status of lamps and beep and

turn OFF the Power Switch.

• If the display is one of those shown in “4. Displays and beeps

when there is an equipment failure” in “3-3 Interpreting beeps
and displays” on page 39, take the necessary measures and
then go back to (1) on page 31.

• If no Battery Mode is performed and the UPS and the devices

connected to the UPS stop, this may be attributed to an insuffi-
cient battery charge.

After connecting the AC input plug to a wall outlet (commercial
power) and waiting at least 8 hours for the battery to charge (24
hours when an additional battery unit is connected), go back to
(4) on page 31.

• If the problem persists after checking the 2 points above, con-

tact us; ____

See also

 Setting switch  1  can be used to turn the beeper ON/OFF.  

➛  Page 43

The status indicator returns to its normal state and the beeping sound stops.
(The status is as shown below.)

Checking the operation is now complete.

Installation and connection is now complete.

   (        indicates blinking)

Status indicator

Description

Backup is operating due to power failure or AC input error.

Output will stop if Battery Mode continues.

(Same as above.)

Battery level is low, so output will stop soon.

Battery is dead, so output stopped. (This is displayed only

for a few seconds.)

Status indicator

Description

Power switch “ON”

Operating normally

Beep

Intermittent

4-second

intervals

Intermittent

1-second

intervals

None

Output

ON

ON

OFF

Charging

OFF

Discharging

OFF

Discharging

OFF

Discharging